Shanghai Oriental Hongtu Mining Machinery Co

< r/ />


The fine sand recovery machine is used to recover fine sand in the mining industry. If customers want to gain maximum economic benefits, they should use and maintain it correctly. The fine sand recovery machine prevents the loss of fine sand and causes losses. So how to use and maintain it correctly? Let me tell you about it below, I hope it can help the majority of users.


After the fine sand recovery equipment is installed, each mechanism should be inspected and adjusted frequently during use to ensure flexibility and reliability. There should be no dirt on the friction surface. If there is dirt, it must be washed away with gasoline or thinner.
Pay attention to check each screw for broken wires and loose strands. If this happens, it should be replaced immediately.
The cyclone, vibrating screen, slurry pump and other parts should also be inspected regularly to ensure that the equipment can operate normally.
Check the connections of various parts of the fine sand recovery equipment frequently and tighten them if they are loose. The tightness of each bolt in the machine body should be checked when the machine body is under pressure. All connecting shafts must have cotter pins and be fully opened.
On all wires of the fine sand recovery equipment, the cables should always be checked for damage. If there is damage, bandage or replace the damaged part promptly.
Frequently check whether each mechanism is operating normally and whether there is noise. If any fault is found, it must be eliminated in time.
When installing, disassembling and adjusting the slewing mechanism, attention should be paid to ensuring that the center line of the reducer of the fine sand recovery machine is parallel to the center line of the gear, its meshing surface is not less than %, and the meshing clearance must be appropriate.
When encountering overheating of the motor, stop it immediately and continue running after troubleshooting. The motor bearings must be well lubricated.
The control boxes, distribution boxes, etc. should be kept clean at all times, and the dust on the electrical equipment should be cleaned at any time.
The contact opening and closing of the travel switch of each safety device must be safe, and the contact arc craters should be polished in time.